Itona C Series Service Manual
6 Replacing RAM 6. Press the RAM downwards until the clip at each end of the socket lock into position. Note: You will hear a distinctive click, in
Replacing Flash 7 4 Replacing Flash To replace Flash: 1. Remove the power adapter, pedestal and side cover. For more information see, section ‘R
8 Replacing the Motherboard 5 Replacing the Motherboard To replace the mother board: 1. Remove the power adapter, pedestal and side cover. For more
Replacing the Motherboard 9 Figure 10: USB and VGA cable 4. Remove the motherboard screws. Figure 11: Motherboard Screws 5. Disconnect the COM
10 Replacing the Motherboard Figure 12: COM port connector 6. Replace the existing motherboard with a new motherboard. 7. Using the star screwdr
Removing the Power Supply Unit 11 6 Removing the Power Supply Unit To replace the power supply unit: 1. Disconnect the ATX power supply cable. 2.
12 Removing the Power Supply Unit Figure 15: Power Supply Screws 5. Remove this power supply unit. You may replace a new unit in its place. Fig
Copyright © 2004-2013 VXL Instruments Limited. All Rights Reserved Information in this document is subject to change without notice and does not rep
Table of Contents 1 Tools Required ...
Warning and Caution Statements Warning: It is best to wear an electrostatic discharge (ESD) cuff when handling electronic components (Motherboard,
Tools Required 1 1 Tools Required The tools required for servicing the Itona C Series Thin Client are shown in Figure 1. Figure 1: Tools Required
2 Tools Required B. Phillips screwdriver C. Hex Nut driver 5.0 mm D. Nose pliers with spring
Pedestal and Side Cover 3 2 Pedestal and Side Cover Removing the Pedestal and Side Cover The procedure to remove the power adapter, pedestal and top
4 Pedestal and Side Cover 5. Slide the side cover and remove it as shown in Figure 4. Figure 4: Side Cover Fixing the Pedestal and Side Cover To
Replacing RAM 5 3 Replacing RAM To replace RAM: 1. Remove the power adapter, pedestal and side cover . For more information see, section ‘Removing
Comments to this Manuals